Toshiba T2100 Series Maintenance Manual page 54

3. To select the DIAGNOSTIC TEST option from the DIAGNOSTICS MENU, set
the highlight bar to 1, and press Enter . The following screen will appear:
TOSHIBA personal computer T2100 DIAGNOSTICS
version X.XX (c) copyright TOSHIBA Corp. 19XX
DIAGNOSTIC TEST MENU :
1 - SYSTEM TEST
2 - MEMORY TEST
3 - KEYBOARD TEST
4 - DISPLAY TEST
5 - FLOPPY DISK TEST
6 - PRINTER TEST
7 - ASYNC TEST
8 - HARD DISK TEST
9 - REAL TIMER TEST
10 - NDP TEST
11 - EXPANSION TEST
88 - ERROR RETRY COUNT SET [HDD & FDD]
99 - EXIT TO DIAGNOSTICS MENU
Refer to Sections 3.4 through 3.14 for detailed descriptions of each Diagnostic
Test (1 through 11). Function 88 sets the floppy disk drive and hard disk drive
error retry count. Function 99 exits the submenus of the Diagnostic Test and
returns to the Diagnostic Menu.
4. Select the option you want to execute and press Enter . The following message
will appear:
SYSTEM TEST
SUB-TEST : XX
PASS COUNT: XXXXX ERROR COUNT: XXXXX
WRITE DATA: XX
ADDRESS : XXXXXX STATUS
SUB-TEST MENU :
01 - ROM checksum
02 - HW status
03 - Version check
99 - Exit to DIAGNOSTIC TEST MENU
NOTE: The menu displayed by your T2100/T2105 Series computer may be
slightly different from the one shown above.
3-4
XXXXXXX
READ DATA : XX
: XXX
↑ ↓ → ← : Select items
Enter : Specify
Esc : Exit
T2100 DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break]; test end
[Ctrl]+[C] ; key stop
↑ ↓ → ← : Select items
Enter : Specify
Esc : Exit
T2100 Series