Toshiba T2100 Series Maintenance Manual page 153

5. Lift the LCD module out of the frame.
6. Gently grip the FL cable's connector with a pair of needle nose pliers and discon-
nect the FL cable. Be very careful not to damage the connector and cable (Figure
4-27).
7. Remove the four flat-head M2x4 screws securing the SEG board and rotate the
board out so that it lies flat. Be sure no dust or debris contaminates the unit
(Figure 4-27).
8. Remove the two ground plates located at each end of the SEG board (Figure 4-
27).
9. Slip your finger under the P chassis and release the five latches securing it to the
B/L holder (Figure 4-27).
T2100 Series
Figure 4-27 Removing the SEG board
4-39