Intermec CK30 User Manual page 148

Chapter 6 — Troubleshooting and Maintaining the CK30
Problems While Scanning Bar Codes (continued)
Problem
Your 1551E or 1553 scanner
stopped working after you activated
energy saver mode or connected a
cable.
134
Solution
You can enable energy saver mode only if the
scanner is connected to the CK30 by an energy
saving cable.
Follow these steps:
Disconnect the scanner from the CK30.
1
Find the Reset Factory Defaults bar code in
2
the scanner documentation.
While pulling the trigger, hold the scanner
3
over the Reset Factory Defaults bar code, and
apply external power to the scanner. The
scanner is reset to factory defaults.
Use Configuration Utility or Intermec Settings
4
to disable energy saver mode on the CK30.
Use Configuration Utility or Intermec Settings
5
to disable the port on the CK30.
Attach the scanner to the CK30.
6
Use Configuration Utility or Intermec Settings
7
to enable the port.
Use the scanner to scan a bar code. The
8
scanner should work now, but energy saver
mode is disabled.
Continue with Steps 9 through 11 only if you
want to use energy saver mode.
Install the correct energy saving cable. Use
9
P/N 3-606034-02 for the 10-pin scanner port,
or use P/N 3-606032-03 for the serial port.
Use Configuration Utility or Intermec Settings
10
to enable energy saver mode on the CK30.
Use the scanner to scan a bar code. Energy
11
saver mode is enabled.
CK30 Handheld Computer User's Manual