Snmp User Table - D-Link xStack DGS-3426G User Manual

SNMP User Table

This window displays all of the SNMP users currently configured on the Switch.
To view this window, click Administration > SNMP Manager > SNMP User Table, as shown below:
To delete an existing SNMP User Table entry, click the
delete.
To display the detailed entry for a given user, click the View button under the Display heading. This will open the SNMP User
Table Display window, as shown below.
The following parameters are displayed:
Parameter
User Name
Group Name
SNMP Version
Auth-Protocol
Priv-Protocol
To return to the SNMP User Table, click the
Table, click the Add button on the SNMP User Table window. This will open the SNMP User Table Configuration window, as
shown below.
®
xStack DGS-3426G Layer 2 Gigabit Ethernet Managed Switch
Figure 2 - 74 SNMP User Table window
Figure 2 - 75 SNMP User Table Display window
Description
An alphanumeric string of up to 32 characters. This is used to identify the SNMP users.
This name is used to specify the SNMP group created can request SNMP messages.
V3 – Indicates that SNMP version 3 is in use.
None – Indicates that no authentication protocol is in use.
MD5 – Indicates that the HMAC-MD5-96 authentication level will be used.
SHA – Indicates that the HMAC-SHA authentication protocol will be used.
None – Indicates that no privacy (encryption) protocol is in use.
DES – Indicates that DES 56-bit encryption is in use based on the CBC-DES (DES-56)
standard.
Show All SNMP User Table Entries
below the Delete heading corresponding to the entry you wish to
link. To add a new entry to the SNMP User
72