Protocol Vlan Group Settings - D-Link xStack DGS-3426G User Manual

Table 3 - 2 Protocol VLAN and the corresponding protocol value
To achieve this goal, users must first properly set the type of protocol, along with the identifying value located in the packet
header and apply it to a protocol group, which is identified by an ID number. Once the group has been created and configured,
then users must add it to a port or set of ports using the Protocol VLAN Port Settings window, and configure the appropriate
VLAN and priority tags for these untagged packets. When these actions are completed and saved to the switch, then the ingress
and untagged packets can be appropriately dealt with and forwarded through the switch.

Protocol VLAN Group Settings

This window is used to begin the Protocol Group VLAN configurations.
To view this window, click L2 Features > VLAN > Protocol VLAN > Protocol VLAN Group Settings, as shown below:
Click the Add button to reveal the following window for the user to configure:
®
xStack DGS-3426G Layer 2 Gigabit Ethernet Managed Switch
Protocol
IP over Ethernet
IPX 802.3
IPX 802.2
IPX SNAP
IPX over Ethernet2
decLAT
SNA 802.2
netBios
XNS
VINES
IPV6
AppleTalk
RARP
SNA over Ethernet2
Figure 3 - 17 Protocol VLAN Group Settings window
Type Header in Hexadecimal Form
0x0800
0xFFFF
0xE0E0
0x8137
0x8137
0x6004
0x0404
0xF0F0
0x0600
0x0BAD
0x86DD
0x809B
0x8035
0x80D5
118