D-Link xStack DGS-3426G User Manual page 89

Users now have the choice of adding an IPv4 or an IPv6 host to the SNMP host table. To add a new IPv4 entry to the Switch's
SNMP Host Table, click the Add IPv4 Host button in the upper left-hand corner of the window. This will open the SNMP Host
Table Configuration window, as shown below.
The following parameters can set:
Parameter
Host IPv4 Address
SNMP Version
Community String or
SNMP V3 User Name
To add a new IPv6 entry to the Switch's SNMP Host Table, click the Add IPv6 Host button in the upper left-hand corner of the
window. This will open the SNMP Host Table Configuration window, as shown below.
The following parameters can set:
Parameter
Host IPv6 Address
SNMP Version
®
xStack DGS-3426G Layer 2 Gigabit Ethernet Managed Switch
Figure 2 - 84 SNMP Host Table Configuration window for IPv4
Description
Type the IPv4 address of the remote management station that will serve as the SNMP host
for the Switch.
V1 – This specifies that SNMP version 1 will be used.
V2 – To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv – To specify that the SNMP version 3 will be used, with a NoAuth-NoPriv
security level.
V3-Auth-NoPriv – To specify that the SNMP version 3 will be used, with an Auth-NoPriv
security level.
V3-Auth-Priv – To specify that the SNMP version 3 will be used, with an Auth-Priv security
level.
Type in the community string or SNMP V3 user name as appropriate.
Figure 2 - 85 SNMP Host Table Configuration window for IPv6
Description
Type the IPv6 address of the remote management station that will serve as the SNMP host
for the Switch.
V1 – To specifies that SNMP version 1 will be used.
V2 – To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv – To specify that the SNMP version 3 will be used, with a NoAuth-NoPriv
78