Table of Contents
Advertisement
Figure 5 - 20 Access Rule Table window (Packet Content Mask)
To remove a previously created rule, select it and click the
Figure 5 - 21 Access Rule Configuration window (Packet Content Mask)
To set the Access Rule for the Packet Content Mask, adjust the following parameters and click Apply.
Parameter
Profile ID
Mode
®
xStack
DGS-3426G Layer 2 Gigabit Ethernet Managed Switch
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port defined
button. To add a new Access Rule, click the Add button:
199
Advertisement
Table of Contents
