Table of Contents
Advertisement
Figure 3 - 23 Link Aggregation Group Configuration window (Modify)
The user-changeable parameters are as follows:
Parameter
Group ID
State
Master Port
Unit
Member Ports
Flooding Port
Active Port
Type
®
xStack
DGS-3426G Layer 2 Gigabit Ethernet Managed Switch
Description
Select an ID number for the group, between 1 and 32.
Trunk groups can be toggled between Enabled and Disabled. This is used to turn a port
trunking group on or off. This is useful for diagnostics, to quickly isolate a bandwidth
intensive network device or to have an absolute backup aggregation group that is not under
automatic control.
Choose the Master Port for the trunk group using the drop-down menu.
Select the switch in the switch stack to be modified.
Choose the members of a trunked group. Up to eight ports per group can be assigned to a
group.
A trunking group must designate one port to allow transmission of broadcasts, multicasts and
unknown unicasts.
Shows the port that is currently forwarding packets.
This drop-down menu allows users to select between Static and LACP (Link Aggregation
Control Protocol). LACP allows for the automatic detection of links in a Port Trunking Group.
124
Advertisement
Table of Contents
