Table of Contents
Advertisement
Methods
Click Apply to implement changes made.
Authentication Guest VLAN Settings
This window is used to display and configure the Authentication Guest VLAN settings on the Switch.
To view this window, click Security > Common Authentication > Authentication Guest VLAN Settings, as shown below:
To configure a new entry click the Add button, to reveal the following window:
The following parameters may be set:
Parameter
VID / VLAN Name
Port List(e.g.:1,6-9)
Action
Click Apply to implement changes made.
®
xStack
DGS-3426G Layer 2 Gigabit Ethernet Managed Switch
keep trying until the next authentication.
Host Based – Each user can be authenticated individually.
None – Specifies that multiple authentication is not enabled.
Any – Specifies that a client will gain access if it passes any of the authentication (802.1X,
MAC or JWAC).
802.1X+IMPB – Specifies that 802.1X+IMPB can be enabled on a port at the same time.
802.1X will be verified first, and then IMPB will be verified. Both authentication methods need
to be passed. If either authentication method fails, the client will be denied to access.
IMPB+JWAC – Specifies that JWAC and IMPB can be enabled on a port at the same time.
JWAC will be verified first, and then IMPB will be verified. Both authentication methods need to
be passed. If either authentication method fails, the client will be denied to access.
Figure 6 - 67 Authentication Guest VLAN Settings window
Figure 6 - 68 Authentication Guest VLAN – Add window
Description
Select either VID or VLAN Name and enter the appropriate information about a previously
configured VLAN.
Enter the port or list of ports you wish to configure. Check the Select All Ports check box to
select all ports.
Select the action you wish to apply to the Guest VLAN.
Select Add to add a port to the Guest VLAN portlist or Delete to remove ports from the Guest
VLAN portlist.
279
Advertisement
Table of Contents
