Installing The Spinner; Installing The Fuselage Servos; Horizontal Stabilizer; Installing The Switch - Seagull Models Arising Star Assembly Manual

Arising Star.

INSTALLING THE SPINNER.

Install the spinner backplate, propeller and
spinner cone. The spinner cone is held in
place using two 3mm x 12mm wood screws.
The propeller should not touch any part
of the spinner cone. If it does, use a sharp
modeling knife and carefully trim away the
spinner cone where the propeller comes in
contact with it.

INSTALLING THE SWITCH.

Install the switch into the precut hole in the
servo tray, in the fuselage, from the bottom.
Use the two screws provided with the switch
to secure it in place. Drill two 3/32" holes
through the tray for the screws to pass
through.
Switch.
10
Instruction Manual.

INSTALLING THE FUSELAGE SERVOS.

Rudder servo.
Throttle servo.
Elevator servo.

HORIZONTAL STABILIZER.

PARTS REQUIRED
{1} Horizontal Stabilizer with Elevator
Halves
ALIGNING THE HORIZONTAL STABILIZER.
1) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at the trail-
ing edge, and place a mark. Use a triangle
and extend this mark, from back to front,
across the top of the stabilizer. Also extend
this mark down the back of the trailing edge of
the stabilizer.
Draw centerline.
The top of the stabilizer does not have
the hinge pins exposed.
2) Using a modeling knife, carefully re-
move the covering from over the vertical sta-
bilizer mounting slot in the top of the fuselage.
3) Slide the stabilizer into place in the pre-
cut slot in the rear of the fuselage. The stabi-
lizer should be pushed firmly against the front
of the slot.
Remove covering.