How To Monitor, Stop Monitoring An Instant Track Route - Furuno FAR-3210 Operator's Manual

14. HOW TO MONITOR ROUTES
14.7.5

How to monitor, stop monitoring an instant track route

How to monitor an instant track route
If the route check results is "OK", click the [Monitor] button on the [Planning] page in
the [Instant Track] dialog box to start monitoring the instant track route. Click the but-
ton before the time remaining counts to zero, otherwise the instant track will be can-
celled, followed by the message "Instant Track is expired." After the [Monitor] button
is clicked the [Monitoring] page is opened. The [Monitoring] page shows the name of
the instant track and the instant track mode.
The vessel follows the instant track route in the same method as a monitored route,
which is grayed out to indicate it is inactive. For the instant track route connected to a
monitored route, the previous instant track route is also greyed out to show it is inac-
tive. Any additional instant track routes are erased.
To close the [Instant Track] dialog box, click the [Close] button. (The system continues
monitoring the instant track route.)
The following occurs when sensor data is lost while using the instant track function.
Monitoring condition
Instant track route monitor-
ing.
No monitored route
Monitored route active
14-10
Click the
[Monitor] button.
• An instant track route under creation is deleted. No
route can be created.
• The [Stop] button is pushed or the instant track route
is followed until its completion.
• After the instant track route is completed, an error
message appears and the [Instant Track] dialog box
closes.
An instant track route under creation is deleted.
After the route is completed, an error message appears
and the [Instant Track] dialog box closes.
Result