How To Select A Color Palette - Furuno FAR-3210 Operator's Manual

1. OPERATIONAL OVERVIEW
Note 2: If the ambient temperature is less than 0°C (32°F) when the power is applied,
nothing appears on the display and the Status LED on the Control Unit flashes. This
is because the heater is warming the unit. The display appears in approx. two minutes.
How to power off the system
Press the power switch on the Processor Unit or a Control Unit. Push the Mains switch
for the "O" position.
Note: Provided that the radar was once in use with the transmitter tube (magnetron)
still warm, you can put the radar in transmit state without three minutes of warm-up. If
the Power switch was turned off by mistake or the like and you wish to restart the radar
promptly, turn on the Power switch not later than 10 seconds after power-off.
1.3

How to Select a Color Palette

This radar provides three sets of color and brilliance sets (palette), day, dusk and
night, to match any ambient lighting condition. The default specifications of each pal-
ette are as shown in the table below. The panel dimmer setting is automatically
changed, and the number of steps depends on the color palette selected.
Palette
Day-gray
Day-blue
Dusk-gray
Dusk-blue
Night-gray
Night-blue
To select a palette, do the following:
1. Click the [Palette] button.
[Palette]
button
1-6
Brilliance
MU-190 MU-231
86 88
86 88
77 79
77 79
53 53
53 53
Panel dimmer Text
(step) color
15 White
15 White
7 Light gray
7 Light gray
3 Orange
3 Light gray
Background
color
Gray
Blue
Dark gray
Dark blue
Dark gray
Dark blue