Furuno FAR-3210 Operator's Manual page 38

1. OPERATIONAL OVERVIEW
No. Name
2 Sensor information,
datum box
3 Menu
4 Information box
5 TT/AIS setting box
6 Trail box
7 Alert box
8 Acquisition zone box
9 VRM boxes
10 Target list button
11 Trial maneuver box
12 Drop mark 2 box
13 EBL boxes
14 Mark box
15 Drop mark1 box
16 PI line box
17 Watch box
18 InstantAccess bar
19 Tuning bar
20 Range/Presentation
mode box
21 REF point box
22 Heading line
23 Bearing scale
24 Cursor position box
25 EBL1
26 EBL2
27 VRM1
28 VRM2
29 Drop mark 1
30 Drop mark 2
31 Antenna marker
32 Own ship marker
33 Stern marker
34 North marker
35 Range rings
1-10
Shows your ship's heading, heading source, ship's speed, water
tracking speed, speed source, course over ground, speed over
ground, course and speed source, ship's position, position source,
chart datum.
Note: Position source shall meet the requirements of IMO
MSC.112(73).
Drop-down menu with various radar and chart functions.
Provides various navigation data and route information.
Sets the parameters for TT and AIS targets.
Sets the parameters for the target trails.
Shows alert messages by alert name and alert number.
• Unacknowledged or regenerated alerts flash in red (alarm) or yel-
low-orange (warning).
• Acknowledged alerts are shown in normal video.
Sets an acquisition zone for TT, AIS.
Shows the range and TTG to the VRM1, VRM2.
Displays the TT and AIS target list.
Sets the parameters for the trial maneuver.
Shows the bearing and range to the drop mark 2.
Shows the bearing to the EBL1, EBL2.
Selects the mark to inscribe on the radar display.
Shows the bearing and range to the drop mark 1.
• Adjusts the direction and width of the parallel index lines.
• Activates or deactivates the parallel index lines.
Counts down the time remaining until the buzzer sounds to alert the
operator to view the radar picture.
Quick access to often-used radar, chart radar and chart functions. For
radar and chart radar functions, see section 1.8. For chart functions,
see paragraph 6.1.3.
Shows tuning status. (No function with solid state radar.)
• Selects the radar range.
• Selects the presentation mode.
Selects the reference point (antenna or CCRP) for measurements
(range, bearing, etc.) and markers (position, etc.)
Indicates ship's heading.
The bearing scale provides an estimate of the bearing to a target.
This box shows
• Latitude and longitude of the cursor position.
• Range and bearing to the cursor position.
• TTG to the cursor position.
Measures the bearing to a target.
Measures the range to a target.
Finds the range and bearing to drop mark position.
A cross marks antenna position.
An inverted "T" marks your ship's position.
Marks location of stern.
Marks North.
Provide an estimate of the range to a target.
Description