How To Restore A Profile To The Default Settings; How To Change The Settings On The Current Display To The Recommended Settings - Furuno FAR-3210 Operator's Manual

1. OPERATIONAL OVERVIEW
1.21.4

How to restore a profile to the default settings

1. Click [
2. Select a profile number from the "Profile" drop-down list.
3. Click [Restore Default Settings]. The confirmation message "Attention: This profile
will be restored to the default. Do you wish to continue?" appears.
4. Click [Yes].
Note: This setting for the default is available when selecting a profile to activate next
time (see paragraph 1.21.3).
1.21.5 How to change the settings on the current display to the rec-
ommended settings
1. Click [
2. Click [Default Settings]. The confirmation message "Attention: Settings will be
changed to the default. Do you wish to continue?" appears.
3. Click [Yes]. The settings on the following table are changed to the recommended
settings.
Note: This function is not available when using the interswitch function (see
section 2.29).
RAIN, SEA
GAIN, EAV
Automatic Clutter Elimina-
tion (ACE)
TUNE (other than solid
state radar)
TX CH (for solid state ra-
dar)
RANGE
VRM1
VRM2
EBL1
EBL2
Presentation mode
Off Center
Trail
Past POSN
Lost TGT
TT ACQ
Vector
AZ1, AZ2 (acquisition
zone)
AIS
Association
CPA/TCPA
1-32
] on the Status bar then click [Manage Profile].
] on the Status bar.
Items
AUTO
No change
OFF
TUNE AUTO
No change
6 NM, 6 SM, 6 km, 6 kyd
0.25 NM, 0.25 SM, 0.25 km, 0.25 kyd
OFF (No change)
ON (No change)
OFF (No change)
North-up TM
Note: Head-up RM with no heading or position data.
The ship's position is put beyond 75% of the range scale.
Trail time: 6 min, Trail mode: True-G
OFF
OFF
No change
Note: TT OFF with no heading data.
Vector time: 6 min, Vector reference: REL
OFF
DISP ALL
Note: FUNC OFF with no heading or position data.
TT (>)
CPA: 2 NM, TCPA: 12 min
Settings