Blockhead™ Ii Moving Head Fixture; Getting Started; What's In The Box; Getting It Out Of The Box - Blizzard Lighting Blockhead II User Manual

Table of Contents

Advertisement

1. GETTING STARTED

What's In The Box?

• 1 x BlockHead™ II Moving Head Fixture
• 2 x Omega 1/4 Turn Mounting Brackets
• A Sweet Safety Cable & Set of Mounting Brackets
• An Ever-So-Handy Power Cord
• This Lovely User Manual

Getting It Out Of The Box

Congratulations! You have just purchased a the coolest quad-color RGBW 5x5 pixel matrix
moving head fixture on the market with infinite pan, infinite tilt, and infinite awesomeness!
So now that you're the proud owner of a BlockHead™ II (or hopefully, BlockHeads!), you
should carefully unpack the box and check the contents to ensure that all parts are present
and in good condition. If anything looks as if it has been damaged in transit, notify the
shipper immediately and keep the packing material for inspection. Again, please save the
carton and all packing materials. If a fixture must be returned to the factory, it is important
that the fixture be returned in the original factory box and packing.

Powering Up!

All fixtures must be powered directly off a switched circuit and cannot be run off a
rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer
channel is used solely for a 0% to 100% switch.
AC Voltage Switch - Not all fixtures have a voltage select switch, so please verify that the
fixture you receive is suitable for your local power supply. See the label on the fixture or
refer to the fixture's specifications chart for more information. A fixture's listed current
rating is its average current draw under normal conditions. Check the fixture or device
carefully to make sure that if a voltage selection switch exists that it is set to the correct
line voltage you will use.
Warning! Verify that the voltage select switch on your unit matches the line
voltage applied. Damage to your fixture may result if the line voltage applied does
not match the voltage indicated on the voltage selector switch. All fixtures must
be connected to circuits with a suitable Ground (Earthing).

Getting A Hold Of Us

If something is wrong, please contact us at www.blizzardlighting.com/tickets.
We'll be happy to help, honest.
Blizzard Lighting
N16 W23390 Stoneridge Dr. Ste E
Waukesha, WI 53188 USA
www.blizzardlighting.com
414-395-8365
Disclaimer: The information and specifications contained in this document are subject
to change without notice. Blizzard Lighting™ assumes no responsibility or liability for any
errors or omissions that may appear in this user manual. Blizzard Lighting™ reserves the
right to update the existing document or to create a new document to correct any errors
or omissions at any time. You can download the latest version of this document from www.
blizzardlighting.com.
Author:
J. Thomas
BlockHead™ II User Manual Rev. A
Date:
4/6/2015
Page 3
Last Edited:
J. Thomas
Date:
5/7/2015
(c) 2015 Blizzard Lighting, LLC

Advertisement

Table of Contents
loading

Table of Contents