Replacing The Pcie Expansion Board; Installing The Battery On The Airflow Guide - HP Integrity rx2660 User's & Service Manual

Figure 6-44 Installing the Battery on the Airflow Guide
4. Plug the battery cable into the connector on the SAS core I/O RAID board.
5. Replace the top cover, unless you continue with replacing the PCIe expansion board. See
"Replacing the Top Cover" (page
(page 195).
6. If rack mounted, slide the server completely into the rack, unless you continue with replacing
the PCIe expansion board. See
"Replacing the PCIe Expansion Board" (page
7. Reconnect the power cables and power on the server, unless you continue with replacing
the PCIe expansion board. See
"Replacing the PCIe Expansion Board" (page

Replacing the PCIe Expansion Board

To replace the PCIe expansion board, follow these steps:
1. Make sure the board rail clip are in the open position.
2. Guide the PCIe expansion board into the rails, and seat the board into the slot on the system
board.
NOTE:
3. Push the board rail clips toward the PCIe expansion board to lock the board in place.
"Inserting the Server into the Rack" (page
"Powering On and Powering Off the Server" (page
The PCIe expansion board and slot are keyed to fit only one way.
Removing and Replacing the Smart Array P400 Controller and PCIe Expansion Board
145), or proceed to "Replacing the PCIe Expansion Board"
195).
195).
144), or proceed to
78), or
195