Shutting Down Openvms - HP Integrity rx2660 User's & Service Manual

1. Access the EFI Shell environment for the server on which you want to boot OpenVMS.
Log in to the iLO 2 MP and enter CO to choose the system console.
NOTE:
(the main EFI menu). If you are at another EFI menu, choose the Exit option from the
submenus until you return to the screen with the EFI Boot Manager heading.
2. From the EFI Boot Manager menu, choose the EFI Shell menu option to access the EFI Shell
environment.
3. At the EFI Shell environment, issue the map -fs command to list all currently mapped
bootable devices.
The bootable file systems are listed as fs0:, fs1:, and so on.
4. Access the bootable partition (fsX: where X is the file system number) for the device you
want to boot OpenVMS.
For example, enter fs2: to access the bootable partition for the bootable file system number
2.
The EFI Shell prompt changes to reflect the file system currently accessed.
NOTE:
the server boots, or when the map -r command is issued).
5. When accessing the bootable partition for the desired boot device, issue the
\efi\vms\vms_loader command to initiate the vms_loader.efi loader on the device
you are accessing.
fs5:> \efi\vms\vms_loader.efi
HP OpenVMS Industry Standard 64 Operating System, Version V8.3
© Copyright 1976-2006 Hewlett-Packard Development Company, L.P.
%DECnet-I-LOADED, network base image loaded, version = 05.13.00
%SMP-I-CPUTRN, CPU #02 has joined the active set.
%SMP-I-CPUTRN, CPU #03 has joined the active set.
%SMP-I-CPUTRN, CPU #01 has joined the active set.
%SYSINIT-I- waiting to form or join an OpenVMS Cluster
%VMScluster-I-LOADSECDB, loading the cluster security database
%EWA0, Auto-negotiation mode assumed set by console
%EWA0, Merl5704 located in 64-bit, 66-mhz PCI-X slot
%EWA0, Device type is BCM5704C (UTP) Rev B0 (21000000)
%EWB0, Auto-negotiation mode assumed set by console
%EWB0, Merl5704 located in 64-bit, 66-mhz PCI-X slot
%EWB0, Device type is BCM5704C (UTP) Rev B0 (21000000)
%PKA0, Copyright (c) 2001 LSI Logic, PKM V1.1.01
%EWA0, Link up: 1000 mbit, full duplex, flow control disabled
NOTE:
output shown here.
6. Exit the console and iLO 2 MP interfaces when finished using them.
7. Enter Ctrl-B to exit the system console and return to the iLO 2 MP Main Menu. To exit the
iLO 2 MP, enter x at the iLO 2 MP Main Menu.

Shutting Down OpenVMS

This section describes how to shut down the HP OpenVMS operating system on an rx2660 server.
From the OpenVMS DCL prompt, issue the @SYS$SYSTEM:SHUTDOWN command to shut down
the OpenVMS operating system. Use the following steps:
When accessing the console, confirm that you are at the EFI Boot Manager menu
The file system number might change each time it is mapped (for example, when
Due to the type of server you purchased, your output may not exactly match the
Chip LSISAS1068
Booting and Shutting Down HP OpenVMS 97