Replacing A Power Supply; Removing And Replacing A Hard Drive Filler; Removing A Hard Drive Filler; Removing And Replacing A Power Supply - HP Integrity rx2660 User's & Service Manual

Figure 6-1 1 Removing and Replacing a Power Supply

Replacing a Power Supply

To replace a power supply, follow these steps:
1. Remove the metal filler panel, if necessary.
2. Supporting the power supply with both hands, slide it into the empty slot until it clicks into
place (2).
IMPORTANT:
filler panel.
3. Plug the power cord into the power supply receptacle.
4. Attach the power cord to the power cord anchor attached to the power supply.

Removing and Replacing a Hard Drive Filler

There are hard drive fillers installed in a vertical orientation for all slots that do not contain a
hard drive. The slot fillers are hot-swappable.
IMPORTANT:
a hard drive.

Removing a Hard Drive Filler

To remove a hard drive filler, follow these steps:
1. Squeeze the tabs on the front of the filler to release it from the slot in the drive bay (1).
2. Pull gently until the filler slides out of the server (2).
Ensure the power supply is flush with the adjacent power supply or metal
For cooling purposes, always leave hard drive fillers in slots that do not contain
Removing and Replacing a Hard Drive Filler 155