Booting And Shutting Down Microsoft Windows; Adding Microsoft Windows To The Boot Options List - HP Integrity rx2660 User's & Service Manual

1. Log in to OpenVMS running on the server that you want to shut down.
Log in to the iLO 2 MP for the server and use the Console menu to access the system console.
Accessing the console through the iLO 2 MP enables you to maintain console access to the
server after HP OpenVMS has shut down.
2. At the OpenVMS DCL prompt issue the@SYS$SYSTEM:SHUTDOWN command and specify
the shutdown options in response to the prompts given.
$@sys$system:shutdown
How many minutes until final shutdown [0]:
Reason for shutdown [Standalone]:
Do you want to spin down the disk volumes [NO]?
Do you want to invoke the site-specific shutdown procedure [YES]?
Should an automatic system reboot be performed [NO]?
When will the system be rebooted [later]:
Shutdown options (enter as a comma-separated list):
REMOVE_NODE
CLUSTER_SHUTDOWN
REBOOT_CHECK
SAVE_FEEDBACK
DISABLE_AUTOSTART
POWER_OFF
BIB_STATE
Shutdown options [NONE]: REBOOT_CHECK
%SHUTDOWN-I-BOOTCHECK, performing reboot consistency check...
%SHUTDOWN-I-CHECKOK, basic reboot consistency check completed
%SHUTDOWN-I-OPERATOR, this terminal is now an operator's console
%SHUTDOWN-I-DISLOGINS, interactive logins will now be disabled
%SET-I-INTSET, login interactive limit = 0, current interactive value = 1
%SHUTDOWN-I-SHUTNET, the DECnet network will now be shut down
NOTE:
Due to the type of server you purchased, your output may not exactly match the output
shown here.

Booting and Shutting Down Microsoft Windows

This section describes how to boot and shut down Microsoft Windows on entry-class HP Integrity
servers and how to add Windows entries to the system boot options list.
• "Adding Microsoft Windows to the Boot Options List" (page 98)
• "Booting the Microsoft Windows Operating System" (page 100)
• "Shutting Down Microsoft Windows" (page 101)

Adding Microsoft Windows to the Boot Options List

To add a Microsoft Windows entry to the system boot options list you must do so from EFI by
using the \MSUtil\nvrboot.efi utility to import boot options from the
EFI\Microsoft\WINNT50\Boot00... file on the device from which Windows is loaded.
This procedure adds the Microsoft Windows item to the boot options list.
98 Booting and Shutting Down the Operating System
SHUTDOWN -- Perform an Orderly System Shutdown
on node NODE1
Remaining nodes in the cluster should adjust quorum
Entire cluster is shutting down
Check existence of basic system files
Save AUTOGEN feedback information from this boot
Disable autostart queues
Request console to power-off the system
Request console to reboot all CPUs to the Itanium BIB state
HP OpenVMS I64 currently does not support the POWER_OFF shutdown option.