Removing And Replacing The Smart Array P400 Controller And Pcie Expansion Board; Removing The Optional Smart Array P400 Controller And Battery - HP Integrity rx2660 User's & Service Manual

9. Back up the TPM security information. See the operating system documentation for more
information.
Removing and Replacing the Smart Array P400 Controller and PCIe
Expansion Board
The rx2660 server has two slots on the system board for the optional Smart Array P400 controller,
and the PCIe expansion board. The PCIe expansion board enables the Smart Array P400 controller
slot.
WARNING!
from the server prior to performing this procedure.
Voltages are present at various locations in the server whenever an ac power source is connected.
This voltage is present even when the main power switch is off.
Failure to observe this warning can result in personal injury or equipment damage.
CAUTION:
follow ESD safety precautions can result in damage to the server.

Removing the Optional Smart Array P400 Controller and Battery

To remove the optional Smart Array P400 controller, follow these steps:
1. Power off the server and disconnect the power cables. See
the Server" (page
2. If rack mounted, slide the server completely out from the rack. See
from the Rack" (page
3. Remove the top cover. See
4. Disconnect the internal SAS cables attached to the board. See
Ensure that the system is powered off and all power sources are disconnected
Observe all ESD safety precautions before attempting this procedure. Failure to
78).
143).
"Removing the Top Cover" (page

Removing and Replacing the Smart Array P400 Controller and PCIe Expansion Board

"Powering On and Powering Off
"Extending the Server
144).
Figure 6-41.
191