Installing The Server; Safety Information - HP Integrity rx2660 User's & Service Manual

3 Installing the Server

This chapter provides information and procedures to install the server, and addresses the following
topics:
• "Safety Information" (page 42)
• "Installation Sequence and Checklist" (page 43)
• "Unpacking and Inspecting the Server" (page 43)
• "Installing Additional Components" (page 45)
• "Installing the Server into a Rack or Pedestal" (page 64)
• "Connecting the Cables" (page 65)
• "Connecting and Setting Up the Console" (page 67)
• "Accessing the Host Console" (page 76)
• "Powering On and Powering Off the Server" (page 78)
• "Verifying Installed Components In the Server" (page 80)
• "Installation Troubleshooting" (page 83)

Safety Information

Use care to prevent injury and equipment damage when performing removal and replacement
procedures. Voltages can be present within the server. Many assemblies are sensitive to damage
by electrostatic discharge (ESD).
Follow the safety conventions listed below to ensure safe handling of components, to prevent
injury, and to prevent damage to the server:
• When removing or installing any server component, follow the instructions provided in this
guide.
• If installing a hot-swappable or hot-pluggable component when power is applied (fans are
running), reinstall the server cover immediately to prevent overheating.
• If installing a hot-pluggable component, complete the required software intervention prior
to removing the component.
• If installing an assembly that is neither hot-swappable nor hot-pluggable, disconnect the
power cable from the external server power receptacle before starting the installation.
WARNING!
from the server prior to removing or installing server hardware (unless you are removing
or installing a hot-swappable or hot-pluggable component).
Voltages are present at various locations within the server whenever an ac power source is
connected. This voltage is present even when the main power switch is off.
Failure to observe this warning can result in personal injury or equipment damage.
• Do not wear loose clothing that can snag or catch on the server or on other components.
• Do not wear clothing subject to static charge buildup, such as wool or synthetic materials.
• If installing an internal assembly, wear an antistatic wrist strap and use a grounding mat,
such as those included in the Electrically Conductive Field Service Grounding Kit (HP
9300-1155).
• Handle accessory boards and components by the edges only. Do not touch any metal edge
connectors or any electrical components on accessory boards.
42 Installing the Server
Ensure that the system is powered off and all power sources are disconnected