Table of Contents
Advertisement
Section 3: Installation
Install the adapter plate on the E Series projector (described in 3.9.1) before
mounting to the stacking frame.
1.
Make sure the pitch is to its maximum, prior to placing the projector from
the front.
2.
Place the projector into the stacking frame.
NOTE: There are two ways of placing the projector into the stacking frame: from the top or from the
front.
3.
Make sure the bottom base plate of the frame is aligned with the projector.
4.
Use a 6 mm Allen key to tighten the (6) M8 bolts securing the base plate to
the bottom of the stacker adapter plate.
3.9.3 Stacking Multiple Projectors
NOTE: The projectors can be stacked and hoisted in either an upright or inverted positions.
1.
With one person positioned on each side of
the stacking frame, lift the top stacking frame
onto the bottom stacking frame, aligning all
four stacking legs between the frames.
NOTE: Remove the locking pin from each stacking leg prior to alignment
™
and ensure the four stacking legs are fully seated on the lower stacking
frame.
DANGER
3-12
Stacking Frame Attachments
Step 2 is a critical safety procedure
that MUST be observed. Failure to
engage the locking pin may cause
the projectors to separate, resulting in
possible injury or death.
1450.50 mm
980.00 mm
E Series User Manual
020-000515-01 Rev. 2 (03-2013)
Hide quick links:
Advertisement
Table of Contents
