Rear Lcd Customer Display - Micros Systems Workstation 4 Setup Manual

What's Inside?
Hardware Updates

Rear LCD Customer Display

The following procedure describes how to attach the Rear LCD Customer
Display to the case and connect it to the system board cable. The display is
provided as a complete assembly, ready to install.
1. Remove the WS4 top cover as described on page 2-2.
2. The interface cable is pre-installed on WS4s shipped after May 2004 (S/N
4083019472).
If the cable is not installed, proceed to Step 4, otherwise continue with
o
the next step.
3. Connect the cable from the LCD Display assembly to the cable protruding
through the opening in the shield cover. Figure 2-15. Skip to Step 8,
Figure 2-15: Connecting the LCD Customer Display
4. Obtain display interface cable P/N 400416-007.
5. Remove the RF shield cover as described on page 2-2.
6. Attach 400416-007 to System Board connector J1. Figure 2-16.
Figure 2-16: Attaching the Rear LCD Cable to the System Board
2-18 Workstation 4 Setup Guide