Chapter 2 - What's Inside; Disassembling The Workstation 4 - Micros Systems Workstation 4 Setup Manual

What's Inside?

Disassembling the Workstation 4

Disassembling the Workstation 4

The following procedure describes how to disassemble the workstation and
access the internal components.
1. Remove all cables from the workstation I/O panel including the AC Power
Cable before disassembling the unit.
2. Place a towel or other soft cloth on your work surface to protect the LCD
and touchscreen glass, then place the workstation face down on this
surface.
The WS4 cover is held in place by a pair of screws accessible from the
o
underside of the unit as shown in the top half of Figure 2-1. A pair of
hinges are located at the rear of the base. Figure 2-1.
Figure 2-1: WS4 Cover Hinges and Screws
2-2
SHOCK HAZARD
When the AC Power Cable is connected to the
workstation, hazardous AC and DC voltages are present
in the power supply. Always remove the AC power cable
from the unit before you open the cover.
Workstation 4 Setup Guide