Micros Systems Workstation 4 Setup Manual page 35

3. Loosen the two captive screws from the under side of the unit as shown in
Figure 2-1
4. Remove the top cover from the base. To avoid damaging the hinges on the
rear of the base, push the top cover towards the rear of the base a little to
release them, then lift up. If you lift up on the cover without first releasing
the hinges, you can break them.
5. Raise the rear of the cover and remove the toroid mounted to the RF shield
as shown in Figure 2-2. The toroid is fastened to a cable held in place on
the RF shield with a pair of clips.
Figure 2-2: Removing the Mag Stripe Reader Cable Toroid
6. When you remove the toroid and cable from the clips, lift the top cover and
position it directly in front of the base.
Workstation 4 Setup Guide
What's Inside?
Disassembling the Workstation 4
2-3