What's Inside?
Disassembling the Workstation 4
10. Remove the LVDS cable and toroid from the clips on the RF shield.
Remove the toroid from the LVDS cable by releasing the latch as shown in
Figure 2-6.
Figure 2-6: Removing the LVDS Cable from the Toroid
11. Lift up to remove the RF shield and take care to avoid damaging the LVDS
or Backlight Cable.
Figure 2-7 shows the workstation with the RF shield removed and points
out system board and power supply.
Figure 2-7: Workstation with RF Shield Removed
2-6
Workstation 4 Setup Guide