Operation Of The Data Terminal - JRC JSS-2250 Instruction Manual

4.1.2

Operation of the data terminal

Basically, the every function concerning the telex mode such as ARQ/FEC communication or
scanning can be operated from the data terminal.
To connect and install the data terminal, setup the 7.6 Option menu of the controller.
●
To set the communicate mode to the telex mode, press the Enter key of the keyboard.
●
Additionally, that operation acquires the access right if the controller connected to that data
terminal does not have the access right.
Every function of the data terminal can be operated from the main menu displayed on a
●
regular screen, excluding the screen of communication modes other than the telex, telex
communicating screen, the telex file editing screen.
Because the short-cut key to the table of next page is allocated in each item of the main
●
menu or the drop down menu, it is possible to execute it easily according to few procedures.
● The guide of the item shown with the cursor is basically displayed under the screen in the
data terminal.
While displaying the menu screen on the controller, the data terminal cannot be operated
●
temporally. Similarly, the controller cannot be operated during the telex communication
except the operations of
Besides the telex communication in ARQ/FEC mode, the data terminal has other functions
●
such as editing telex messages and the station list, setup of the radio condition, or setup of
the display color of the screen.
The communication using ARQ mode can be started with a specific radio station by inputting
●
the selcal number (ID) and the work frequency.
The communication using CFEC mode can be started as the broadcasting by inputting the
●
work frequency.
The communication using SFEC mode can be started as the broadcasting for a selected
●
group by inputting the selcal number (group ID) and work frequency.
● The telex communication channel can be set by specifying ARQ or FEC in the DSC message.
In this case, the telex communication may be started without inputting 9 digits selcal number
(ID) and work frequency because those have been already set by the DSC calling.
Up to 20 stations can be registered in the station list.
●
The self-diagnosis of the data terminal is executed from the controller as well as other units.
●
The controller outputs the printing data from the printer connected to the data terminal.
●
The condition of the data terminal such as the startup or the sleep is synchronized to the
●
controller connected or the system.
When the data terminal detects any error(s) concerning to the internal flash memory, the
●
keyboard, the printer or the connected USB memory, immediately shows the popup screen
and the Information is displayed on the bottom line on the screen until the error is fixed.
TEL DSC CW and DISTRESS keys.
Operation
4-3