4.8 USB memory operation
This section describes how to use the USB memory.
・ The following conditions are required for the USB memory.
Not all USB memories satisfying the every condition are guaranteed.
- The specification is complied with USB 1.1 or USB 2.0 standards.
- No USB hub is built-in and is used to connect the USB memory.
- No security function such as encryption or password to access is included.
- No write-protect function is included, or that function is set to "Writable".
- Already formatted with FAT16 or FAT32 by Windows® OS.
・ Only the USB memory is connectable to the USB memory connector.
・ When the USB memory size is large, the file access time will be longer than small one.
・ The files or folders named with multibyte character prepared by other than the data terminal
cannot be accessed.
・ If the USB memory is removed, always close the connector with the rubber cap to ensure the
water-proof and dust-proof performance.
・ Initializing the USB memory will erase all data on the USB memory.
・ To avoid abnormal conditions, do not use the USB memory that has the broken file system.
If displaying the message of "Press Enter key to get the access right in the NBDP
mode..." on the data terminal, press Enter key on the keyboard.
The operation of the data
terminal becomes possible in
the telex mode, except when
the controller is used.
After checking the USB mark indicating on the top of the display of the data terminal,
select File from the main menu and the objective dropdown menu.
To start either one of Edit existing file, Rename file, Delete file, or Copy file, input "A:" as
the USB drive.
To initialize the USB memory, select Initialize USB and operate in accordance with the
message on the dialog box.
To unmount the USB memory, select Remove USB and operate in accordance with the
message on the dialog box. After completing the unmount and the USB mark of the top of
the display is erased, the USB memory can be safely removed from the data terminal.