Setting The Radio - JRC JSS-2250 Instruction Manual

Operation

4.3 Setting the radio

This section describes how to set the communication frequencies and how to use the receiver
and transceiver functions.
4.3.1 Setting the communication frequencies
Use the free frequency input mode to input the communication frequencies directly.
■ ■
Procedure
1 1 . .
1 .
In the status display, use the numeric keypad
to input the frequency.
- When 1 is input using the numeric
Note
keypad, it appears on the far right as
shown in the screen on the right.
In the user/ITU channel input mode,
-
press the
hide the channel display.
2 2 . .
2 .
Input numbers to the 0.1 kHz place and
press ENT.
The transmission frequency input mode opens as
shown in the screen at right.
For a simplex frequency, press ENT to
Note
automatically input the same frequency
as the reception frequency to complete
communication frequency settings.
3 3 . .
3 .
Input the transmission frequency in the
same way as the reception frequency.
4 4 . .
4 .
Input numbers to the 0.1 kHz place and
press ENT.
The communication frequency settings are
complete.
- The reception frequency can be changed on the 0.1 kHz scale by the jog dial.
Note
For simplex frequencies, the transmission frequency is changed at once.
- The above operation is unavailable in the telex mode. The telex frequency is
set with the menu of the data terminal, as Tune
4-24
CH key once or twice to
I D 4 3 1 0 0 1 2 3 4 T I M E 2 3 : 5 9 ( U T C )
P o s 8 9 ﾟ 5 9 . 0 1 2 3 ' N
1 7 9 ﾟ 5 9 . 6 7 8 9 ' E @ 2 3 : 5 9
TEL
.1
RX
2331.5
TX
S I G
W K R s c a n b a n d s :
2 4 6 8 1 2 1 6 ( M H z )
I D 4 3 1 0 0 1 2 3 4 T I M E 2 3 : 5 9 ( U T C )
P o s 8 9 ﾟ 5 9 . 0 1 2 3 ' N
1 7 9 ﾟ 5 9 . 6 7 8 9 ' E @ 2 3 : 5 9
TEL
12345.6
RX
12012.3
TX
S I G
W K R s c a n b a n d s :
2 4 6 8 1 2 1 6 ( M H z )
Tx/Rx frequency set.
( E X T )
kHz
kHz
( E X T )
kHz
kHz