Viewing The Alarm History - JRC JSS-2250 Instruction Manual

6.3.2

Viewing the alarm history

The following describes how to view alarm information detected by the equipment or a history of
past occurring alarms in the 6.2 Alarm information menu.
■ ■
Procedure
1 1 . .
1 .
Press the
MENU
hierarchical menus, select 6.2 Alarm
information.
One of the screens shown at right is
displayed indicating if an alarm is
occurring
.
The displayed alarm information is
Note
formatted as follows.
[Unit Name] : [Alarm Number], [Information]
2 2 . .
2 .
To check the alarm history, press ENT.
The popup screen at right is displayed,
select OK.
3 3 . .
3 .
The alarm history is displayed.
Up to 100 of the latest histories are stored.
If necessary, scroll with the jog dial.
Note
The displayed alarm history is
formatted as follows.
[Number] [Alarm & recovery time] [A: Alarm/V: Recovery]
[Unit name] : [Alarm number], [Information]
key, and through
Maintenance & Inspection
6.2)Alarm information
No data
Press ENT to view alarm history.
(If there is no alarm)
6.2)Alarm information
PA :001,Overcurrent(A)
PA :008,High-temp
Press ENT to view alarm history.
(If there is an alarm)
6.2)Alarm information
View alarm history?
No data
[ OK ] [Cancel]
Press ENT to view alarm history.
Alarm history
1.2008-12-31 23:59 A
PA :001,Overcurrent(A)
2.2008-12-31 23:59 A
PA :008,High-temp
3.2008-11-30 22:45 V
ATU :019,High-temp
4.2008-11-28 22:11 V
ATU :018,High voltage
6-9