Ndz-127J Data Terminal; Nbdp Setting - JRC JSS-296 Service Manual

4.6 NDZ-127J Data Terminal

4.6.1

NBDP setting

ATTENTION
To enable setting adjustment, remove the cover of the NCT-196N DSC/NBDP MODEM
and insert the switch(S1)-No.3 into the OFF. When adjustment is complete, re-insert
the switch(S1)-No.3 into the ON and replace the cover.
Procedure
(a) Turn on the Power Amplifier "AC" switch and NCT-196N "POWER SWITCH".
(b) Press Enter
(c) Select "System" from the initial display and press Enter .
The pull-down menu for "System" appears.
(d) Select "NBDP setup" from the pull-down menu and press Enter .
The following display (NBDP setup) appears.
[TLX] Tx=12345.6kHz / Rx=12345.6kHz (ITU CH=
File Mode Connect
Scanning info
[No scanning]
Last status messages
Move the cursor to the item you want with ↑,↓,→,← then press Enter
64
of keyboard to change the NBDP mode.
[ STATUS INFO ]
ST-BY
NBDP setup
ARQ/FEC 4- or 5-digit Self-ID
ARQ/FEC 4- or 5-digit Self-ID
GFEC 4- or 5-digit Self-ID
ARQ/FEC 9-digit Self-ID
GFEC 9-digit Self-ID
Answerback
Max. FEC error rate.
Max. automatic call series : 1
Collective FEC receiving
Internal alarm
Time duration for AUOT/MRTX: 10min
Restart
Finite start/restart
[Save] [ Cancel ]
S1
Insert the S1-3 to
OFF at the time of
Self-ID setting.
0) 10-APR-2002 12:00(LT)
Loc: N19.00 E115.30 at 11:00(UTC)
Service System Help System
Tuner/Tx.POWER
TUNER :[READY]
:54321
:54321
Tx.POWER:[FULL]
:11111
:987654321
:222222222
: 54321 FFFFF X
: 30%
: ON
: ON
: ON
: ON
S1
Re-insert the
S1-3 to ON after
Self-ID setting.