JRC JSS-2250 Instruction Manual page 100

Operation
(2) Test call
■ ■
Procedure
1 1 . .
1 .
Press
MENU
hierarchical menus, select 1. DSC
non-distress call.
2 2 . .
2 .
Select Call type and press ENT to move
the cursor to the right. Then use the jog
dial to select SAF/Indv/Test.
3 3 . .
3 .
Press ENT.
The display changes as shown to the right
and the cursor moves to Address.
4 4 . .
4 .
Select Address and press ENT to move
the cursor to the right and input the other
stations 9-digit MMSI.
5 5 . .
5 .
To change the call frequency, select
Calling FRQ and press ENT to move the
cursor to the right. Then select the
distress and safety frequencies using the
jog dial and press ENT.
- The numeric keypad can also be used.
Note
- For information on distress and
safety calls, See "11.1 Frequencies
for distress and safety calls".
- After input is complete, check the
details of the message before
sending it using Preview.
4-50
key, and through
1)DSC non-distress call
Call type :[RTN/Indv/TEL
Address :[ ]
Calling FRQ:[Tx 2177.0kHz]
:[Rx 2177.0kHz]
Working FRQ:[Tx . kHz]
[Rx . kHz]
[Call] [Preview] [Cancel]
1)DSC non-distress call
Call type :[SAF/Indv/Test
Address :[ ]
Calling FRQ:[Tx 2177.0kHz]
:[Rx 2177.0kHz]
Working FRQ:[Tx . kHz]
[Rx . kHz]
[Call] [Preview] [Cancel]
1)DSC non-distress call
Call type :[SAF/Indv/Test ]
Address :[ ]
Calling FRQ:[ 2187.5kHz]
[Call] [Preview] [Cancel]
1)DSC non-distress call
Call type :[SAF/Indv/Test ]
Address :[0 ]
Calling FRQ:[ 2187.5kHz]
[Call] [Preview] [Cancel]
1)DSC non-distress call
Call type :[SAF/Indv/Test ]
Address :[431123456]
Calling FRQ:[ 4207.5kHz]
[Call] [Preview] [Cancel]
]
]