Kramer VS-88HN User Manual page 43

Command - RESET
Command Name
Set: RESET
Get: -
Description
Set: Reset device
Get: -
Response
~nn@RESET␠OK␍␊
Notes
To avoid locking the port due to a USB bug in Windows, disconnect USB connections immediately
after running this command. If the port was locked, disconnect and reconnect the cable to reopen the
port.
Command - SIGNAL
Command Name
Set: -
Get SIGNAL?
Description
Set: -
Get: Get input signal lock status
Response
␠ inp_id,status ␍␊
~ nn@SIGNAL
Parameters
inp_id - input number
status - lock status according to signal validation – 0: Signal or sink is not valid, 1: Signal or sink is
valid, 2: Sink and EDID is valid
Response Triggers
After execution, a response is sent to the com port from which the Get was received
Response is sent after every change in input signal status ON to OFF, or OFF to ON
Notes
40
Command Type - System-mandatory
Permission
Administrator
-
Syntax
#RESET␍
-
Command Type - System
Permission
-
End User
Syntax
-
#SIGNAL?␠inp_id␍
Transparency
Public
-
Transparency
-
Public
VS-88HN - Protocol 3000