Full Width Array Overview - Xerox Color 800i System Administration Manual

Note
If a job is submitted while the refresh mode is running, the refresh mode stops and the
submitted job prints. The refresh mode does not reconvene after the print job is
completed. Another refresh mode will occur after the next 10,000 prints are reached.
Set the system to run automatic fuser belt refreshes at specific intervals:
• Enabling automatic refresh tells the system to run a fuser belt refresh during a
"Waiting for printer" process.
• Refresh Duration can be set between 1-999 minutes.
• Manual Refresh: This option allows you to set up a manual fuser refresh at the point
of need instead of at a scheduled time. You may have both a scheduled refresh time
programmed and also perform a manual refresh at any time.
The duration default time is 60 minutes. If lead edge or side edge defects still occur
upon completion of a 60-minute refresh mode, the refresh time can be changed to a
longer duration to elminate these defects.

Full Width Array Overview

The Full Width Array feature uses xerographic parameters and diagnostics to scan the
finished image and correct errors in registration, density and color. This is the process
of calibrating the Print Server with the digital press.
Note
If the Full Width Array feature is not available on your press, contact your Xerox
representative.
With the Full Width Array, thare are internal color calibration strips (or tiles) used as
reference for known colors of a test pattern. These color values are automatically adjusted
to produce accurate and consistent reproductions, and this means that no longer is
customer intervention required.
Note
Refer to your Print Server user documentation when performing the calibration workflow
of the Print Server in conjunction with the digital press.
Xerox ® Color 800i/1000i Presses Xerox
System Administration Guide
® Color 800/1000 Presses
System Settings
5-19