Perfect Binder Settings; Selecting The Output Device Options - Xerox Color 800i System Administration Manual

Note
The Auto Output Switching and Auto Output Switching Priority options are available
ONLY when there is more than one HCS attached to the machine.
• Auto Output Switching Priority: Set the priority order each attached HCS.
• Unload Timing: This option sets how the HCS Unload button functions.
- Unload at set boundary: Selecting this option causes the HCS to stop after
delivering output at the end of the set when the Unload button is pressed.
- Unload immediately: Selecting this option causes the HCS to stop after delivering
the scheduled paper immediately when the Unload button is pressed. This may
occur in the middle of a job set, and the last set delivered may not be a complete
set.
Note
If more than one HCS is attached to the machine, the option selected here applies
to all of them.

Perfect Binder Settings

Select the desired settings for the Perfect Binder power saver mode:
• Glue Heater Timeout: Select a time interval for when the adhesive unit shuts off and
the binder enters power saver mode after the last job in the queue was completed.The
time interval represents a period of system inactivity without any jobs printing or
any jobs in the queue waiting to be printed. Choose between 1-240 minutes. The
default setting is 10 minutes.
• Manual Feed Timeout: Select a time interval for when the adhesive unit shuts off
and the binder enters power saver mode after the last manual feed job was
completed.The time interval represents a period of system inactivity without any
jobs printing or any jobs in the queue waiting to be printed. Choose between 1-240
minutes. The default setting is 10 minutes.

Selecting the Output Device options

1. Logon as Administrator.
2. Select the System Settings button.
3. Select the Output Devices tab.
4. Select the desired High Capacity Stacker Settings.
Note
The Auto Output Switching and Auto Output Switching Priority options are available
ONLY when there is more than one HCS attached to the machine.
5. Select the desired Perfect Binder Settings.
6. Select OK to save your changes and close the System Settings window.
7. Select Logoff to exit the Administrator mode.
Xerox ® Color 800i/1000i Presses Xerox
System Administration Guide
® Color 800/1000 Presses
System Settings
5-17