Transmitting A Group Call - Standard Horizon MATRIX GX3000S Owner's Manual

tered.
11. If a mistake was made entering in the name or the
MMSI number repeat pressing the [ H/L ( NAV )] key
until the wrong character is selected, then move the
channel knob to correct the entry.
12. To store the data entered, press and hold the [ ENT ] key.
13. To enter another individual address, repeat steps 4 through 12.
14. To exit this menu and return to radio operation mode press the [ 16/9 ] key.

11.7.2 Transmitting a Group Call

Pre-Programmable Calling
1. Press the [ CALL ( MENU )] key. The "
menu will appear.
2. Turn the CHANNEL selector knob to select "
(To cancel, select "
knob or press [ 16/9 ] key.)
3. Press the [ ENT ] key. The transceiver will beep, and
the "
Group Directory Group Directory Group Directory Group Directory Group Directory
4. Turn the CHANNEL selector knob to select the
" Group Group Group " you want to contact.
Group Group
5. Press the [ ENT ] key, then turn the CHANNEL selec-
tor knob to select the operating channel you want to
communicate on and press the [ ENT ] key.
6. Press the [ ENT ] key again to transmit the Group Call
signal.
7. After the GROUP CALL is transmitted, all the radios
in the group will switch to the designated channel.
8. Listen to the channel to make sure it is not busy,
then key the microphone and call the other vessels
you desire to communicate with.
GX3000S
" with the CHANNEL selector
Exit Exit Exit Exit Exit
" will appear.
DSC Operation DSC Operation "
DSC Operation DSC Operation DSC Operation
."
Group Group Group Group Group
Page 49