Changing The Time Location; Changing Cog To True Or Magnetic - Standard Horizon MATRIX GX3000S Owner's Manual

8.6 CHANGING THE TIME LOCATION

Sets the radio to show UTC time or local time with the offset inputted in section
8.5 Changing the GPS Time.
1. Press and hold down the [ CALL ( MENU )] key until
" Radio Setup Radio Setup
Radio Setup Radio Setup Radio Setup
2. Press the [ ENT ] key, then select "
"
Radio Setup Radio Setup Radio Setup Radio Setup Radio Setup
knob.
3. Press the [ ENT ] key.
4. Turn the CHANNEL selector knob to select "
" Local Local ."
Local Local Local
5. Press the [ ENT ] key to store the selected setting.
6. To exit this menu and return to radio operation mode
press the [ 16/9 ] key.
In the local time mode, the display shows the time by the 12-hour system.
Meanwhile, the display shows the time by the 24-hour system in the UTC
mode.

8.7 CHANGING COG TO TRUE OR MAGNETIC

Allows customizing the NAV data showing GPS Course Over Ground (COG).
Factory default is True however following the steps below the COG can be
changed to Magnetic.
1. Press and hold down the [ CALL ( MENU )] key until
" Radio Setup Radio Setup Radio Setup
Radio Setup Radio Setup
2. Press the [ ENT ] key, then select "
CHANNEL selector knob.
3. Press the [ ENT ] key.
4. Turn the CHANNEL selector knob to select "
resenting "Magnetic") or "
5. Press the [ ENT ] key to store the selected setting.
6. Turn the CHANNEL selector knob to select "
then press the [ ENT ] key to return to the "
Setup Setup " menu, select "
Setup Setup Setup
to return to radio operation.
GX3000S
" menu appears.
" menu with the CHANNEL selector
( "UTC" mode )
" menu appears.
Off Off " (representing "True").
Off Off Off
" and press the [ ENT ] key
Exit Exit
Exit Exit Exit
Time Disp Time Disp Time Disp " in the
Time Disp Time Disp
UTC UTC UTC " or
UTC UTC
( "LOCAL" mode )
Magnetic Magnetic " with the
Magnetic Magnetic Magnetic
" (rep-
On On On On On
Exit Exit Exit Exit Exit
Radio Radio
Radio Radio Radio
,"
Page 13