4IPNET HSG260 User Manual page 186

Including SDS200W into Your Network
The following diagram illustrates some deployment examples that show how the SDS200W can be connected to
the POS printer and 4ipnet Gateways/Controllers.
SDS200W
PRT-100
Hotel Help Desk
1. Put relevant devices in place.
2. Attach a SDS200W to a power adaptor provided in the package.
3. Attach a POS printer to a power adaptor provided in the package and turn on the power switch situated on the
left side of the device.
4. Connect a POS printer to the Console port of SDS200W by a RS-232 cable provided within the POS printer
package.
5. Connect SDS200W to your 4ipnet Gateway/Controller via Ethernet port or wirelessly. If you are to do it
wirelessly, conduct a site survey in the first place. The wireless coverage is subject to change.
You need to connect to the correct LAN port if your Gateway/Controller is operating
 Note:
in Port-based mode.
To verify if the deployment works fine. Press FUNC + '1' + ENTER to see if SDS200W is attached to a correct
6.
gateway and get an IP address from it. Additionally, press 'Number' + ENTER to see if an account with a certain
billing plan can be printed out.
Managing SDS200W on the Web Management Interface
SDS200W is designed specifically to operate in conjunction with all 4ipnet Gateways/Controllers, including both
HSG and WHG series. If you are not using default settings, before connecting SDS200W to your 4ipnet
Gateway/Controller, some configurations steps are required.
Go to the Web Management Interface (WMI) for SDS200W's relevant configurations. The default values are:
HSG 260
181
HSG Wireless Hotspot Gateway ENGLISH
SDS200W
PRT100
Hotspot 1
PRT200
Hotspot 2
User's Manual
HSG327