System Requirement; Installation Steps - 4IPNET HSG260 User Manual

2.4 System Requirement


Gigabit Ethernet network cables with RJ-45 connectors.

All PCs need to install the TCP/IP network protocol.

2.5 Installation Steps

Please follow the steps mentioned below to install the hardware of the HSG gateway:
1. Place the HSG gateway at the best location.
The best location is usually at the center of your wireless network.
2. To supply power to the HSG gateway.
Connect the power adapter to the HSG gateway's power jack socket on the rear panel.
3. Connect HSG gateway to your outbound network device.
Connect one end of the Ethernet cable to the WAN port of HSG the gateway on the rear panel. Depending on
the type of internet service provided by your ISP, connect the other end of the cable to the ATU-Router of an
ADSL, a cable modem, a switch or a hub. The WAN LED indicator should be ON to indicate a proper
connection.
4. Connect the HSG gateway to your PC.
Connect one end of the Ethernet cable to the LAN1 port of the HSG gateway on the rear panel. Connect the
other end of the cable to a PC for configuring the system. The LAN1 LED indicator should be ON to indicate a
proper connection.
Note:
The HSG gateway has two virtual Private and Public zones that are mapped to LAN1, LAN2
(192.168.1.254) and LAN3, LAN4 (192.168.11.254) respectively on the HSG260.
The HSG gateway has two virtual Private and Public zones that are mapped to LAN1 (192.168.1.254)
and LAN2 (192.168.11.254) respectively on the HSG320/HSG327.
Now, the hardware installation is complete.
Caution:
Please use only the power adapter supplied with the HSG package. Using a different power adapter may cause
damage to this system.
Caution:
To verify the wired connection between the HSG gateway and your switch/router/hub. Please check the LED status
indication of these network devices.
HSG Wireless Hotspot Gateway ENGLISH
8
User's Manual