Right Side Panel Overview
Right Side Panel
1. Kensington Lock
2. Restart / Reset
3. TAS
Left Side Panel Overview
Left Side Panel
1. Console
2. Ethernet
3. 5V / 1.5A
4. Antenna
connector
Caution:
The SDS200W requires a lower voltage for operation even though it has the same power adaptor socket as
PRT100. Make sure that the correct power adaptor is used (5V/1.5A) for SDS200W.
Be used to lock the device to a pole.
Press once to reboot the system. Hold for five seconds to make SDS200W set
back to factory default settings.
Terminal Auto Setup (TAS). Press three seconds to initiate the auto uplink
connection process. This will be introduced later.
Serial port for connecting to a POS printer.
RJ-45 Ethernet port Serial port for connecting to the uplink gateway via wire.
The DC power socket for connecting to an external power source through a
DC power supply.
Assemble the dipole antenna within the package here.
HSG Wireless Hotspot Gateway ENGLISH
180
User's Manual