4IPNET HSG260 User Manual page 184

LED Panel
LED indicators
Power
Status
Ethernet
WLAN
Understanding the LED indicators
There are four LED indicators on the panel : Power, Status, LAN, and WLAN from left to right. Below summarizes
all indication types in different states:
Amplitude
long illuminated
intervals
Amplitude
Constantly off
short illuminated intervals or long illuminated intervals.
When the power adapter is connected, Power will become constantly on; when
disconnected, the light turns into constantly off. Always check if Power is on
before using SDS200W.
1. Short illuminated intervals means SDS200W successfully booted up. It
flashes slowly.
2. Long illuminated intervals means SDS200W and uplink device connected
3. Special flashing means the keypad locked. The indicator fast-blinks twice
periodically.
Note: <TAS Mode only>
4. Fast flashing means SDS200W trying to connect to uplink device.
5. Constantly off for ten seconds means SDS200W fails to connect to uplink
device after step 4. Afterwards, Status will go back to step 1.
6. Constantly on for ten seconds means SDS200W succeeds in connecting to
uplink device after step 4. Afterwards, Status will go to step 2.
Ethernet turns into constantly on when an Ethernet cable is connected.
Ethernet blinks when the system detects wired traffic passing Ethernet. It is
constantly off when no cable is connected.
WLAN behaves similarly as Ethernet - becoming constantly on when wireless
connectivity is enabled (not necessarily connected. It just means that the RF
card is ready to serve). WLAN blinks when the system detects wireless traffic. It
is constantly off if the RF card is disabled.
Amplitude
Constantly on
t
Amplitude
t
Special flashing
HSG Wireless Hotspot Gateway ENGLISH
Amplitude
Fast Flashing
t
Amplitude
Short illuminated
t
intervals
179
User's Manual
t
t