Status Light - Intermec SG20T1D User Manual

Status Light

SG20T Tethered Scanner User's Guide
The status light on the SG20T flashes red or green depending on the
status of the scanner.
Default Status Light Description
Light State
Series of green
flashes (USB
interface only)
Green light on for 2
seconds
Green light flashes 2
times
Red light on for 2
seconds
Chapter 2 — Scanning with the SG20T
What it Means
Power-up
At power-up the status light flashes to indicate the
activated USB interface:
—1 flash = Keyboard HID
—3 flashes = Virtual COM
—5 flashes = HID POS
—6 flashes = IBM POS Hand Held
—7 flashes = IBM POS Table Top
The status light only flashes at power up for a USB
interface.
Note: When changing from one USB interface to
another the scanner restarts and will also flash the
current USB interface.
The scanner successfully decoded a bar code and sent
the data to the host device.
A configuration bar code was successfully read.
Transmission error
OR
Configuration bar code was not accepted
11