Status Light - Intermec SF61 User Manual

Chapter 1 — About the SF61B Cordless Scanner

Status Light

10
Note: The following tables show the default behavior of the status
light, you can use EasySet to modify this behavior if you wish
(Operating settings > Beeps / LEDs).
The status light flashes green or red to indicate the status of the
scanner and/or battery. Status information is sometimes shown even
if the Intermec Ready-to-Work Indicator is on. This way the scanner
can communicate more than one type of information at the same
time.
For example while the blue LED is on to show that there is a
Bluetooth connection, the scanner will flash green when you have
successfully scanned and transmitted a bar code.
Default Status Light Description During Scanner Operation
Light State
Green light on for 2
seconds
Green light flashes
twice
Red light comes on
for 2 seconds
Red blinking slow
Red continuously on
and 6 fast beeps every
2 seconds
Default Status Light Description When the Scanner is Docked in a
Charger
Light State
Red continuously on The battery is not fully charged and is charging.
Green continuously
on
What it Means
The scanner successfully decoded a bar code and sent
the data to the host.
A configuration bar code was successfully read.
Transmission error
or
Configuration bar code was not accepted
Battery power is low (< 20% - need to charge).
NVM (non-volatile memory) problem.
What it Means
The battery is fully charged.
SF61 Cordless Scanner User's Guide