Usb Cable Mode - Intermec SG20T1D User Manual

SG20T Tethered Scanner User's Guide
Hungarian 101-Key

USB Cable Mode

By default the USB cable mode is set to keyboard HID. However you
can also set up your scanner to use the following USB cable modes:
• HID POS
IBM POS Hand Held
•
• IBM POS Table Top
• Virtual COM
USB Keyboard HID (*)
IBM POS Hand Held
USB Virtual COM
Note: When scanning a USB Cable Mode configuration bar code, the
scanner beeps twice then restarts. When it restarts it will beep twice
and flash a series of green flashes to indicate the USB cable mode (see
"Status Light" on page
Chapter 3 — SG20T Interfaces
11).
HID POS
IBM POS Table Top
21