Maintenance Information; Particular Risks - HAKO Hakomatic B45 Instruction Manual

Safety information
1.4

Maintenance information

• Operating personnel must complete
the necessary daily and weekly
maintenance work. All other mainte-
nance work must be completed at
your nearest Hako service center.
• The maintenance work and mainte-
nance intervals prescribed in the
operating manual must be adhered
to.
• Suitable tools must be used for clea-
ning and maintenance work.
• The machine must be inspected by a
recognized technical expert in re-
spect of operational safety, within
the terms of the applicable accident
prevention laws, at reasonable inter-
vals (we recommend at least once a
year) and following modification or
repairs.
• Spare parts must comply with the mi-
nimum technical requirements stipu-
lated by the manufacturer! This is
ensured by the use of original spare
parts.
• Before cleaning and servicing the
machine or replacing parts, switch
off the motors and main switch (Ha-
komatic B45 CL only).
• To prevent unauthorized use of the
machine, remove the key from the
main switch (Hakomatic B45 CL on-
ly).
• Always disconnect the battery termi-
nal before starting any work on the
electrical installation.
• When working in the area of the rai-
sed recovery tank, it must be hinged
open fully to prevent it being knok-
ked shut or further open and down
unintentionally.
• It is not permitted to clean the machi-
ne with a pressure washer or steam
blaster.
• It is not permitted to use aggressive
and corrosive cleaning agents.
• Allow the machine to dry after being
cleaned, e.g. over the weekend.
• Only start the machine up when all
the safety equipment has been in-
stalled and brought to its protecting
position.
1.5

Particular risks

Electronics
• In the case of defects in the electrical
installation, switch the vehicle off im-
mediately and clear the fault.
• Work on the electrical equipment
may only be carried out by electrici-
ans who have received the necessa-
ry training and in accordance with
the electrical engineering regulati-
ons.
• The vehicle's electrical equipment
must be inspected/checked at regu-
lar intervals. Defects, such as loose
connections and cable damage,
must be rectified immediately.
• Only use original fuses with the
prescribed amperage.
9