First Operation; Instruction; Initial Charging Procedure; Before Putting Into Operation - HAKO Hakomatic B45 Instruction Manual

First Operation

2 First Operation
2.1

Instruction

Instruction is required before first ope-
ration. First instruction into handling of
the machine must be held by a qualified
person sent by your local PowerBoss
contract dealer. Your PowerBoss dea-
ler will be informed by the manufacturer
upon delivery of the vehicle and will
contact you to make a date for instruc-
tion.
2.2

Initial charging procedure

Before first operation of the
machine, fully charge the
battery with an initial charging
procedure and comply with the
operating instructions of the
charger as well as with those of
the battery manufacturer. Po-
werBoss cannot be held liable
for damages resulting from an
insufficient initial charge.
2.3

Before Putting into Operation

Complete the following inspections be-
fore taking the machine into operation:
1. Check the area around the machine
for signs of leakage. Hoses, lines
and tanks must be free from any lea-
kage or damage.
2. Install brushes and squeegee, see
maintenance chapter.
3. Install batteries and connect battery
plug, see maintenance chapter.
4. Check battery charge and proceed
to re-charging of batteries if required.
Generally proceed to initial charging
before first operation of the machine.
5. Empty recovery tank and clean it if
required, see maintenance chapter.
6. Re-fill solution tank and add cleaning
agent according to the manufactu-
rer's recommendations.
Use only cleaning agents sui-
table for automatic machines
(low-foaming) and comply with
the instructions for use, dispo-
sal and with the warning infor-
mation specified by the clea-
ning agent's manufacturer.
13