Maintenance Information; Specific Hazards - HAKO Hakomatic B45 Instruction Manual

Safety information
machine, remove the key from the
main switch (Hakomatic B45 CL/
CLH only).
• When transporting the machine, the
squeegee and brush head must be
raised. The way of driving must be
adapted to the local conditions.
• The machine has been conceived for
use on level surfaces with a maxi-
mum gradient of 2%.
1.4

Maintenance information

• Operating personnel must complete
the necessary daily and weekly
maintenance work. All other mainte-
nance work must be completed at
your nearest Hako service center.
• The maintenance work and mainte-
nance intervals prescribed in the
operating manual must be adhered
to.
• Suitable tools must be used for clea-
ning and maintenance work.
• The machine must be inspected by a
recognized technical expert in re-
spect of operational safety, within
the terms of the applicable accident
prevention laws, at reasonable inter-
vals (we recommend at least once a
year) and following modification or
repairs .
• Spare parts must comply with the mi-
nimum technical requirements stipu-
lated by the manufacturer! This is
ensured by the use of original spare
parts.
• Before cleaning and servicing the
machine or replacing parts, switch
off the motors and main switch (Ha-
komatic B45 CL/CLH only).
• To prevent unauthorized use of the
machine, remove the key from the
main switch (Hakomatic B45 CL/
CLH only).
• Always disconnect the battery termi-
nal before starting any work on the
electrical installation.
• When working in the area of the rai-
sed recovery tank, it must be hinged
open fully to prevent it being kno-
cked shut or further open and down
unintentionally.
• It is not permitted to clean the machi-
ne with a pressure washer or steam
blaster.
• It is not permitted to use aggressive
and corrosive cleaning agents.
• Allow the machine to dry after being
cleaned, e.g. over the weekend.
• Only start the machine up when all
the safety equipment has been in-
stalled and brought to its protecting
position.
1.5

Specific Hazards

Electric system
• Only use genuine fuses with the
specified ratings.
• In case of malfunction of the electric
system, immediately shutdown ma-
chine and remedy.
• Only qualified personnel are authori-
zed to work on the electrical installa-
tions and only according to electro-
technical rules.
• Inspect/check the electrical equip-
ment of the machine at regular inter-
valls. Clear up any defects
immediately, such as loose connec-
tions or damaged cables.
Battery
• Respect the operating instructions of
the battery manufacturer.
• Never place metal objects or tools on
batteries - short-circuit hazard!
• Due to alteration of the centre of gra-
vity, only use batteries as released
and at the prescribed position only.
• Only charge batteries in areas with
sufficient ventilation. – Explosion ha-
7