HAKO Hakomatic B45 Instruction Manual page 53

Maintenance and Service
Height adjustment
The height adjustment is set to 3 mm at
the factory. If streaks appear despite an
optimum angle adjustment, the di-
stance of the rollers to the floor must be
adjusted by changing the number of
washers on the holder.
3 mm
In the case of very smooth floors, e.g.
varnished floors, linoleum etc.:
4 mm
2 mm
Number of washers = 2. This corre-
sponds to a distance of approx. 2 mm to
the floor.
In the case of very uneven floors, e.g.
badly laid tiles (water does not run off):
Number of washers = 4. This corre-
sponds to a distance of approx. 4 mm to
the floor.
Fig.18
53