Oil Filter Replacement - FNM HPE 300 Owner's Manual

Marine Diesel Engines
5. Connect a pump to the hose end, then open valve A.
6. Open the refill oil cap B to facilitate the suction.
7. Operate manually on the pump to transfer the oil.
8. Disconnect the pump and close the valve (A).
9. Refill the engine with new oil up to proper level.
Respect the environment. Exhaust oils are strongly polluting .Follow the local orders or
laws for disposal.
Follow the instruction below :
1. Turn off the engine and let it cool down adequately.
Prepare a container to collect any leaks. Take care to dismount the oil filter cartridge (H) after
2.
oil from the sump.
3. Unscrew the oil filter element cover (H) with the appropriate wrench.
4. Clean the housing with blotting paper or a clean cloth.
5. Lubricate the rubber O-ring seal and the ring seat before remounting the filter cover.
Reposition the new filter element and tighten the cap with a torque of 25 Nm according to
6.
instructions. Refill the engine with new oil up to proper level.
Turn the engine ON and leave it running at minimum RPM(idle) for few minutes till it reaches
7.
the working temperature. Increase the speed until reaching the maximum and check the oil
pressure level.
ENG rel. 1/11
'
O M
WNER S ANUAL

Oil filter replacement

www.fnm-marine.com
Engine maintenance
HPE300
H
66