Menu - Sim2 Sirio User Manual

To Watch 3D Content via Satellite, Cable and Games Console
•Switch on the SIRIO and all other relevant products such as Satellite receiver and AV
receiver and ensure the correct inputs have been selected.
•Select the appropriate 3D channel.
•If the projector displays two distorted images side by side or one on top of each
other, select the 3D menu by pressing II on the remote control.
•Select 3D mode via the OSD (this will expand the menu). Select the correct version of
the 3D format using the up/down/left/right keys.
•Switch on your 3D glasses. Refer to the instructions supplied with the glasses to
ensure correct operation.
Important: All 3D technologies currently available today filter out a large amount of
light. Therefore it is perfectly normal for the 3D image to be noticeably dimmer when
compared to the picture in 2D mode. Adjust the 3D picture and lamp settings
accordingly for 3D viewing.
3D Glasses
Follow the simple instructions below to operate your 3D glasses.
Turning ON your glasses
Shortly press button once (see "3D Glasses" on page 12). You will see the red LED
indicator change from off to bright, and then turn off again. You are now in SIM2
Cinema mode and the glasses and the projector are synced. If, for any reason, the
glasses behave differently, reset them (see below).
If glasses cannot find 3D RF emitter within few seconds, LED will ramp from bright to
off and glasses will automatically shut down. If glasses find the RF emitter they will
automatically connect to it, indicating by lit LED for 1 second.
Turning OFF Your Glasses
Shortly press button once (see "3D Glasses" on page 12). You will see the red LED
indicator change from bright to off. Glasses will shut down.
Note: For charging the battery to "3D Glasses" on page 19.
3D Menu
To view 3D content additional adjustments are required. With 3D content playing,
press II on the remote to access the OSD 3D menu.
3D Mode
•3D Activates 3D mode and the RF emitter will be activated. Automatic selection is
determined by the source sending the projector the correct information. If the
incorrect 3D image is displayed after approximately 10 seconds go to the 3D Input
Format and manually select the correct 3D mode for the incoming signal.
•2D display mode for normal 2D material. 3D Input Format adjustment is unavailable.
PureMotion adjustment is available.
4 Operation SIRIO 22
User Guide